Replace Gas Stove

After enough repair bills, it's probably time to replace that old gas stove.  The procedure is straight forward, unless you have LP gas.  Units are delivered ready to go for natural gas and require several modifications to convert to bottled gas.  It's not too difficult, just be sure that you follow all of the instructions.  Stove installation is best done by a qualified service technician, though if you are confident, you can do it yourself.  Be sure to obey local codes and ordinances to ensure that homeowner installation is permitted. Here's a list of items you will need.  

Step 1:

You need to disconnect and remove the old unit.  This includes both the gas and the electric.  Before you get started, shut of the gas line.  Close the valve, located either in the basement or at the tank.  To pull the plug, you will need to drag the unit away from the wall.  First lay down a piece of plywood to keep from gouging or scratching the floor.

Step 2: 

At the base of the stove, remove the cover plate with a screwdriver.  If you have old copper tubing, you will first need to disconnect the line at the fitting to the stove.  Loosen the nut and slide this back. This is a flared copper type fitting. Now carefully drag the unit on top of the plywood, avoiding damage to the gas line. Climb in back of the unit and disconnect the old gas line at the coupling, using two wrenches. Be careful not to crimp the cooper piping.

Step 3:

To prepare the new unit for LP gas you need to adjust several items.  First you will need to replace the range orifices or spuds.  These are individually sized with marks and colors.  Using a nut driver, loosen the old spud and replace with the new one.  The trick to keeping from dropping the spud down inside the range is to use a small piece of aluminum foil between the driver and the spud.  This should provide enough "grip".  If you do drop one down inside, you'll need torx wrenches to disassemble the burner units and get inside. The oven orifices need to be adjusted.  Using an open-end wrench, tighten down the brass fitting.  There may be two orifices, one for the broiler and one for the main oven. Underneath the unit, you will need to reverse the plastic pin in the regulator.  Remove the hex nut and flip the plastic pin and reassemble the nut.  Do not over tighten this.  The last step is to open the air shutters as per directions.

Step 4:

To connect the gas line, you will need to purchase a new connector line.  Bring the old connector to the store as you will have to match up pipe thread at the stove with the compression fittings on the old gas line.  Here we use two fittings to make the junction. To make the connection, coat the threads with pipe compound. Tighten the fitting and test by applying very soapy water. (No matches please!)  If it bubbles in a few seconds, you have a leak. Try again!

Step 5:

The anti-tip bracket is mounted to the wall behind the stove.  Simply screw this in as per directions. Move the new stove in place and level the legs.  While there is a hex head inside the unit, it is easier to use a pry bar and slightly lift the unit and turn the legs from beneath the unit. Don't forget to open the gas line. If there is any smell of gas, shut off the supply and call a qualified service technician.