The Tool Barn

Locate conduit runs
Locate conduit runs

Step 5:

You should also locate areas and runs that are easily accessible and have a clear line of sight.

Cut conduit to length
Cut conduit to length

Step 6:

To cut the conduit you can simply use a carpenter's handsaw or power miter box.

Junction box
Junction box

Step 7:

Measure from the end of the conduit with the coupling and remember to start from the inside edge allowing for 3/4" to 1" recess.  Depending on the number of bends, you will need to occasionally use a junction box or pull elbow. 

Elbow
Elbow

Step 8:

For simplicity, you should plan to include a junction box after two elbows. Actually there is more to this, see the reference at bottom of the page on pulling wire calculator. 

Drill through header
Drill through header

Step 9:

At headers and joists you will need to drill through for access.  While a spade bit will work for smaller conduit (up to 1 1/4"), a hole saw is required for larger holes. For concrete foundations, you may need to rent or borrow a larger drill and masonry bit.

Coupling at break box
Coupling at break box

Step 10:

At the junction box, you need to punch out for a coupling, but here's is where you should probably stop and let the electrician help you.   And don't forget - Be sure the power is OFF before removing breaker panel cover!

Coupling on box
Coupling on box

Step 11:

Start at one end of the run, typically the receptacle box.  Here, a male coupling adapter is used to connect to the metal box. 

Apply glue to coupling
Apply glue to coupling

Step 12:

Dry fit the conduit and coupling, then disassemble and apply solvent glue.  Reassemble the unit, giving the pipe a quarter turn twist and let this set for 10 minutes. As you proceed, attach conduit clamps at least every 10 feet or as necessary.

Fish tape
Fish tape

Step 13:

With the conduit in place, you need to measure the length of the wire needed.  You can approximate this with a tape measure, or run a single wire or fish tape through for a measurement.  

Wrap with colored tape
Wrap with colored tape

Step 14:

In order to pull wire, you first need to assemble a bundle.  Start by wrapping the stands around a post.  Then stretch out the cable to length required, being sure to mark the neutral and ground wire with white and green tape at each end. You will need a hot, neutral and a ground wire.

Feed fish tape and pull wire bundle
Feed fish tape and pull wire bundle

Step 15:

Start by feeding the fish tape from one end of the conduit run and attaching your wire strand as a bundle.  To make the wire pull more easily, coat the wire with wire-pulling lubricant as you feed it.  At the junction box, pull the bundle through the first leg and then feed the fish tape through the second leg.

Bundle being pulled through
Bundle being pulled through

Step 16:

Now pull the bundle through the second leg and pull the slack. From this point, you should let the licensed electrician for work inside of the breaker box and make connections at the receptacle box. Even if you turn off the main breaker, the line side of the panel is still HOT!  Accidentally touching these lugs with the wire or fish tape will cause sparks to fly.  Be sure you are wearing eye protection.

Reference:

Conduit specifications from Carlon

Electric code update from Journal of Light Construction

Pulling wire calculator

Using conduit from electrician.com

Glossary of electric terms from Levitron

Building Codes and software

Electrical wiring FAQ from FAQ.org

1 - 2

Related articles


Printer friendly page


E-mail this page to a friend